logo

vlag

Connect

This organ has 3 built in amplifiers and loudspeakers. This third loudspeaker is an extra dimension whith the Orbitone on or when the strings are played. At the front its 3 sources are connected throug a stereo jack connector (8mm). The output level is higher than line level, the volume pedal has to be put at its lowest position for this reason.

It is also possible to take each of the 3 sources by using the connector at the back. Because this is an oldfashion type of connection, it is it will be hard to find a suitable connector. The only way to make a connection rapidly is to solder a cable at the inside of the connector.

Phaser provide with Small stone

The 310 will turn in a Jean Michel Jarre theatre as soon it is connected with an Electro Harmonix Small Stone phaser.

Because the organ is stereo and the Small Stone mono, a stereo to mono cable should be used. Connect the output of the Small Stone at the left channel of the mixing desk and use some delay (about a second). Pan the output of the delay to the right.

---> --->

Built in Orbitone with external input

The organ has a splendid Orbitone [chorus/tremolo] which can also be used externally by using its external input. At the right side of the back of the organ is a mono entrance [jack-connector]. To hear the impact do the following: in the lower-manual turn off the strings, at the Orbitone panel turn on the Principals lowerman. Switch at the Orbitone panel to Chorus or Termolo and hear a splendid stereo result for your self! Balance-, timbre and reverberation faders interfer on the signal.